秦华电子专业生产高压玻璃秞膜电阻器、氧化膜电阻器、线绕电阻器等产品,咨询电话:029-33693465                                 

网站地图   产品中心   公司简介   客户案例



水冷电阻器
您的位置:首页 > 电阻器中心  > 产品展示 > 水冷电阻器

SL型大功率氧化膜水冷电阻器

SL型大功率氧化膜水冷电阻器体积小、功率大。高频性能优越。广泛用于金属件热处理设备的高频电源中和广播电视发射机设备的假负载。

SL型高频大功率水冷电阻器

SL Type High Frequency large Power Water Cooled Resistors


主要特点:小体积、大功率、高频性能优越。广泛用于金属件热处理设备的高频电源中和广播电视发射机设备的假负载。

Chief Characteristic: Small volume. Large power. High frequency is excellent. They are used extensively high frequency power supply equipment of metal thermal treatment and false loads of the sender for the radio and television.

技术标准/Technology Standard

1. GJB3017--97《膜式高压电阻器总规范》

2. QJB/QH1619--2007《RY-GDL型高频大功率氧化膜电阻器详细规范》

外形图/Contour Drawing


 

型号Type

Rated Power (W)

阻值范围

Resistance

Range ()

阻值允差

Resistance

Tolerance (%)

温度系数    Temperature

Coefficient (×10/K)(PPM)

外形尺寸

Contour Dimensions (ΦD×L)(mm)

备注 Remark

SL-I

5000

5-1000

±5-±10

≤±400 (25-125)℃

46×(182±1)

SL-II

10000

10-3000

46×(400±2)

SL-III

33000

10-10000

90×(860±3)

串联 In serise

注意1. 电阻器只准垂直安装,进水口在下;出水口在上。

     

 2. 电阻器每消耗1KW功率,水流量应不小于1公升/min。但降功率使用时,就其水流量而言:5KW电阻器应不低于5公升/min; 10-20KW电阻器应不低于10公升/min; 25KW电阻器应不低于15公升/min

      3. 如果采用循环水冷系统,其出水必须经过冷却处理方可使用, 应当使用去离子水作为冷却介质。

      4. 超出上表所列技术参数,可按用户要求协议供货。

Remarks: 1.The resistor only allowed the vertical installation,water inlet,outlet in.

        2.Resistor per 1kw power consumption,water should not be less than 1liter per minute.But reduced power use,in terms of its water:5kw resistor not less than 5 liters per minute;10-20kw resistor not less than 10 liters per minute;25kw resistor not less than 15 liters per minute.

        3. If using circulating water cooling system, the water must be treated with cooling before use.

        4.Go beyond the afore cited scope,we can provide the products according to the user's requirements.

 

(此内容由www.qhdz.com.cn提供)

快速通道